Re: Multi-Cell Slave-Version 2
Posted: Tue Apr 03, 2012 2:06 pm
V10 good spot
Not sure about CellS
CellS is used to store the unloaded cell voltage from a known acquisition with the loads off.
The sequence goes
1) Turn off loads.
2) Measure cell voltages and store CellV in CellS. Report V to master
3) Turn on loads according to CellS
I'll look at it. Suggest try is as is first to get it working.
If we have thickish short wires to the cells we may be able to revert to the older software where we did not have to turn off the loads to take the cell V
Not sure about CellS
CellS is used to store the unloaded cell voltage from a known acquisition with the loads off.
The sequence goes
1) Turn off loads.
2) Measure cell voltages and store CellV in CellS. Report V to master
3) Turn on loads according to CellS
I'll look at it. Suggest try is as is first to get it working.
If we have thickish short wires to the cells we may be able to revert to the older software where we did not have to turn off the loads to take the cell V