Old BMS Software Thread

Threads relating to the BMS system begun by Peter Perkins

Moderators: GregsGarage, retepsnikrep

isaac_alaska1
Posts: 100
Joined: Sun Apr 03, 2011 7:41 pm

Re: Old BMS Software Thread

Postby isaac_alaska1 » Sat Nov 14, 2015 4:11 am

1.75 is expected with no comms. In order to fit the full cell range into 8 bits, and keep the necessary resolution, the slave subtracts 1.75V from the true cell reading before transmitting. The master then adds 1.75 to the reading before reporting it. So if there are no comms, it reads 0, and adds 1.75V
One test u can do is measure the voltage across the likes of each data bus. They should normally be held high at 5V, and pulled low for each bit that is transmitted.


Return to “BMS thread”

Who is online

Users browsing this forum: No registered users and 24 guests